Figure 111. Installing the rear drive module
2. Fasten the captive screw using the Phillips #2 screw driver.
3. Connect the power cable and signal cables to the rear drive module.
Next steps
1. If removed, Install the cooling fan cage.
2. If removed, install the air shroud.
3. Follow the procedure listed in After working inside the system.
Optional OCP card
Removing the OCP shroud
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
Steps
Hold the edges of the OCP shroud and lift the shroud at an angle out of the system.
Installing and removing system components
113
To Next Page
Loading...
