Dell E75S001 - Optional BOSS S2 Card; Removing the BOSS S2 Card

Figure 93. Installing the MicroSD card
Next steps
1. Install the IDSDM module.
2. Install the air shroud.
3. Follow the procedure listed in the After working inside the system.
Optional BOSS S2 card
Removing the BOSS S2 card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
Steps
1. Lift the retention latch to release the BOSS S2 card carrier.
2. Slide the BOSS S2 card carrier out from the BOSS S2 controller card module.
Installing and removing system components
99