Table 16. Cable routing - 12 x 3.5-inch drive backplane to the rear PERC adapter and with cable riser 1B
and BOSS S2 card (continued)
From To
Signal connector on riser SL7_CPU1_PA4 (Signal connector on riser)
Signal connector on riser SL8_CPU1_PB4 (Signal connector on riser)
Figure 54. Cable routing - 16 x 2.5-inch SAS/SATA + 8 x 2.5-inch NVMe drive backplane to the front PERC with
BOSS S2 card
Table 17. Cable routing - 16 x 2.5-inch + 8 x 2.5-inch drive backplane to the front PERC with BOSS S2
card
From To
DST_PA1 (Signal connector on backplane) SL1_CPU2_PB1 (Signal connector on system board)
DST_PB1 (Signal connector on backplane) SL2_CPU2_PA1 (Signal connector on system board)
DST_PA2 (Signal connector on backplane) SL3_CPU2_PB2 (Signal connector on system board)
DST_PB2 (Signal connector on backplane) SL7_CPU1_PA4 (Signal connector on system board)
CTRL_DST_PA1 (Signal connector on the front PERC) SL3_CPU2_PB2 (Signal connector on system board)
CTRL_SRC_SB1 (Signal connector on the front PERC) DST_SB1 (Signal connector on backplane)
BP_PWR_1 ( Power connector on the backplane) SIG_PWR_1 (Power connector on the PIB)
BP_PWR_1 ( Power connector on the backplane) SIG_PWR_2 (Power connector on the PIB)
PWR_1 (BOSS card power connector) BOSS_PWR (Power connector for BOSS card on system
board)
Signal connector on the BOSS card. SL10_PCH_PA5 (Signal connector on system board)
Installing and removing system components 61
To Next Page
Loading...
