Dell E75S001 - Page 66

Figure 59. Cable routing - 12 x 3.5-inch SAS/SATA drive backplane + Rear 2 x 2.5-inch NVMe with cable riser 1A and
BOSS S2 card
Table 22. Cable routing - 12 x 3.5-inch SAS/SATA drive backplane + Rear 2 x 2.5-inch NVMe with cable
riser 1A and BOSS S2 card
From To
BP_DST_SA1 (Signal connector on backplane) CTRL_SRC_SA1 (Signal connector on PERC adapter)
BP_DST_SB1 (Signal connector on backplane) CTRL_SRC_SB1 (Signal connector on PERC adapter)
BP_PWR_1 (Power connector on backplane) SIG_PWR_1 (Power connector on PIB)
RBP_PWR (Power connector on rear module) SIG_PWR_3 (Power connector on PIB)
RBP_A (SAS/SATA signal connector on rear module) SL3_CPU1_PB2 (Signal connector on PERC adapter)
PWR_1 (BOSS card power connector) BOSS_PWR (Power connector for BOSS card on system
board)
Signal connector on BOSS card SL10_PCH_PA5 (Signal connector for BOSS card on system
board)
RISER_PWR_1 (Power connector on the riser) SIG_PWR_0 (Power connector for cabled riser on system
board)
RISER_DST_PB2 (Signal connector on riser) SL6_CPU2_PB3 (Signal connector on system board)
RISER_DST_PA2 (Signal connector on riser) SL5_CPU2_PA3 (Signal connector on system board)
Signal connector on riser SL7_CPU1_PA4 (Signal connector on riser)
Signal connector on riser SL8_CPU1_PB4 (Signal connector on riser)
66 Installing and removing system components