Dell EMC ML3E User Manual

5. Completely loosen the front captive screws of the Base Module.
6. Slowly extend the Base Module from the front of the rack and remove it from the rack.
7. Place the Base Module on a flat, level surface, such as a table.
8. Remove the top library cover plate, if present.
a. Unlock the top cover with two small screwdrivers.
b. Remove the cover from the module.
Removing the accessor and spooling mechanism from the Base Module
1. Remove the left and right magazines by using the magazine release levers (circled in Figure 71).
Push up on the lever, then pull the magazine out.
2. Slide the cartridge carrier toward the center of the accessor to access the robot-locking lever.
3. Standing at the front of the module, unlock the robot by moving the blue lever to the left, then
toward you, then to the right.
Figure 71. Magazine release levers
Upgrading and servicing 121

Dell EMC ML3E Specifications

General

Product Type	Tape Library
Number of Drives	Up to 3
Interface Type	SAS
Operating Humidity	20% to 80% (non-condensing)
Non-operating Humidity	5% to 95% (non-condensing)
Drive Types	LTO-6, LTO-7, LTO-8
Tape Technology	LTO Ultrium
Form Factor	Rackmount
RAID Support	Not Applicable
Max Data Transfer Rate	Up to 300 MB/s (native)
Operating Temperature	10°C to 35°C
Non-operating Temperature	-40°C to 60°C
Power Supply	Dual redundant power supplies