Dell EMC PowerEdge T640 - Installing the Processor into a Processor and Heat Sink Module

Figure 60. Removing the processor bracket
Next step
Install the processor into the processor and heat sink module.
Related link
Removing the air shroud
Removing a processor and heat sink module
Installing the processor into a processor and heat sink module
Installing the processor into a processor and heat sink module
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Place the processor in the processor tray.
NOTE
: Ensure that the pin 1 indicator on the processor tray is aligned with the pin 1 indicator on the processor.
2 Flex the outer edges of the bracket around the processor ensuring that the processor is locked into the clips on the bracket.
NOTE
: Ensure that the pin 1 indicator on the bracket is aligned with the pin 1 indicator on the processor before placing
the bracket on the processor.
NOTE: Ensure that the processor and the bracket are placed in the tray before you install the heat sink.
118 Installing and removing system components