3 Rotate the rubber cap clockwise to x it over the captive screws.
4 Insert the mating connector into the power supply.
System cover
System cover provides security for the entire system and also helps in maintaining proper air ow inside the system.
Removing the system cover
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Turn o the system and all attached peripherals.
3 Disconnect the system from the electrical outlet and peripherals.
4 If installed, remove the front bezel.
5 Place the system on a at, stable surface.
Steps
1 Turn the latch release lock to the unlocked position.
2 Press the cover release latch and remove the system cover.
Figure 35. Removing the system cover
Next step
Install the system cover.
Related link
Removing the front bezel
Installing the system cover
Installing and removing system components
89
To Next Page
Loading...
