Figure 99. Removing the main PIB
Next step
Install the main PIB.
Installing the main power interposer board
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Align the screw holes on the main power interposer board (PIB) with the holes on the system chassis.
2 Using the Phillips #2 screwdriver, secure the main PIB to the system using the screws.
3 Connect all the disconnected power cables to the main PIB.
Figure 100. Installing the main power interposer board
Next steps
1 If applicable, install the GPU PIB.
2 Install the system board.
3 Install the power supply units.
4 Follow the procedure listed in After working inside your system.
Installing and removing system components
153
To Next Page
Loading...
