Dell EMC PowerEdge T640 - Installing the System Cover; Air Shroud; Removing the Optional GPU Air Shrouds

Installing the system cover
Prerequisite
NOTE: Ensure that all internal cables are connected and placed out of the way and no tools or extra parts are left inside the
system.
Follow the safety guidelines listed in Safety instructions.
Steps
1 Align the tabs on the system cover with the slots on the chassis.
2 Press the cover release latch, and push the cover toward the chassis until the latch locks into place.
3 Rotate the latch release lock clockwise to the locked position.
Next steps
1 Place the system upright on its feet on a at and stable surface.
2 If removed, install the bezel.
3 Reconnect the peripherals and connect the system to the electrical outlet.
4 Turn on the system, including all attached peripherals.
Related link
Installing the front bezel
Air shroud
The air shroud directs the airow across the entire system. Air shroud prevents the system from overheating and is used to maintain
uniform airow inside the system.
Removing the optional GPU air shrouds
Prerequisites
CAUTION
: Never operate your system with the air shroud removed. The system may get overheated quickly, resulting in
shutdown of the system and loss of data.
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
Step
Holding the touch points, press the release latch and lift the shroud out.
90
Installing and removing system components