When you connect the micro-USB Type-B port, it becomes the primary connection and, while connected, all messages are sent
to the micro-USB-B port.
1. Power on the personal computer.
2. Connect the USB Type-A end of cable into an available USB port on the computer.
3. Connect the micro-USB Type-B end of cable into the micro-USB Type-B console port on the switch.
4. Power on the switch.
5. Install the necessary Silicon Labs drivers.
6. Open your terminal software emulation program to access the switch.
7. Confirm that the terminal settings on your terminal software emulation program are as follows:
●
115200-baud rate
● No parity
● Eight data bits
● One stop bit
● No flow control
Management ports 37
To Next Page
Loading...
