About this guide
This guide provides site preparation recommendations, step-by-step procedures for rack mounting and desk mounting your
switch, inserting modules, and connecting to a power source.
CAUTION: To avoid electrostatic discharge (ESD) damage, wear grounding wrist straps when handling this
equipment.
NOTE: Only trained and qualified personnel can install this equipment. Read this guide before you install and power up this
equipment. This equipment contains two power cables. Disconnect both power cables before servicing.
NOTE: This equipment contains optical transceivers, which comply with the limits of Class 1 laser radiation.
Figure 1. Class 1 laser product tag
NOTE: When no cable is connected, visible and invisible laser radiation may emit from the aperture of the optical
transceiver ports. Avoid exposure to laser radiation. Do not stare into open apertures.
Regulatory information
Marketing model Z9432F-ON is represented by the regulatory model E46W and the regulatory type E46W001.
BMC, ONIE, and DIAG OS default login
After you have installed and powered up your switch, you must enter the default username and password.
● Username (BMC): admin
● Username (ONIE and DIAG OS): root
● Password (uppercase): <SERVICE TAG>!
Topics:
• Related documents
• Information symbols
Related documents
For more information about the Z9432F-ON switch, see the following documents:
● Dell EMC SmartFabric OS10 User Guide
● Dell EMC SmartFabric OS10 Release Notes
● Dell EMC PowerSwitch Z9432F-ON Set-up Guide
● Dell EMC PowerSwitch Z9432F-ON Release Notes
1
About this guide 5
To Next Page
Loading...
Need help?
General