Name: Dell Force10 MXL Blade
Brand: Dell
Rating: 4 (1 reviews)

To Next Page

To Previous Page

24 Installing and Configuring the Switch

This is the configuration information that has been

collected:

SNMP Interface = "mxl1"@1.1.1.1

User Account setup = root

Password = ******

Out-of-band IP address = 192.168.2.1 255.255.255.0

VLAN1 Router Interface IP = 2.2.2.80 255.255.255.0

Default Gateway = 192.168.2.0

If the information is correct, please enter (Y) to

save the configuration.

If the information is incorrect, enter (N) to discard

the configuration and restart the wizard: [Y/N] y

Thank you for using the Dell Easy Setup Wizard. You

will now enter CLI mode.

Applying Interface configuration, please wait ...

FTOS>

NOTE: If you do not save the initial configuration settings, they will be lost at the

next switch reboot and the Setup Wizard will be invoked. To save the initial

configuration to the startup configuration, enter the following commands at the CLI

prompt on the attached console:

FTOS> enable

FTOS# write memory

Other manuals for Dell Force10 MXL Blade

Questions and Answers:

Need help?

Do you have a question about the Dell Force10 MXL Blade and is the answer not in the manual?

General