Dell Force10 MXL Blade - Page 23

Installing and Configuring the Switch 23
Next, IP addresses are set up on the OOB (Out-Of-Band)
Interface and/or the VLAN1 routing interface.
You can use these IP addresses to access the CLI, Web
interface, or SNMP interface of the switch.
To access the switch through any Management Interface
you can
. set up the IP address for the Management
Interface.
. set up the default gateway if IP address is
manually configured on the OOB interface.
Would you like to set up the Out-Of-Band interface
now? [Y/N] y
Please enter the IP address of the device (A.B.C.D) or
enter "DHCP" (without the quotes) to automatically
request an IP address from the network DHCP server.
[192.168.2.1]: 192.168.2.1
Please enter the IP subnet mask (A.B.C.D or /nn).
[255.255.255.0]: 255.255.255.0
Please enter the IP address of the default gateway
from which this network is reachable. 0.0.0.0 means
that the default gateway will not be configured
[0.0.0.0]: 192.168.2.0
Would you like to set up the VLAN1 routing interface
now? [Y/N] y
Please enter the IP address of the device (A.B.C.D) or
enter "DHCP" (without the quotes) to automatically
request an IP address from the network DHCP server. :
2.2.2.80
Please enter the IP subnet mask (A.B.C.D or /nn). :
255.255.255.0