Removing the wireless card
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Topics:
• Prerequisites
• Procedure
Prerequisites
1. Remove the stand.
2. Remove the back cover.
3. Remove the system-board shield.
Procedure
1. Remove the two screws (M2x2.5) that secure the wireless-card shield to the system board.
2. Lift the wireless-card shield from the system board.
3. Remove the screw (M2x2.5) that secures the wireless-card bracket and the wireless card to the system board.
4. Slide the wireless-card bracket off the wireless card.
5. Disconnect the antenna cables from the wireless card.
6. Slide the wireless card out of the wireless-card slot.
15
Removing the wireless card 31
To Next Page
Loading...
