Replacing the antennas
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
1. Adhere the antennas to the slot on the display-assembly base.
2. Replace the two screws (M2x2.5) that secure antennas to the display-assembly base.
3. Route the antenna cables through the routing guides on the display-assembly base.
Post-requisites
1. Replace the wireless card.
2. Replace the system-board shield.
3. Replace the back cover.
4. Replace the stand.
18
36 Replacing the antennas
To Next Page
Loading...
