5. Route the camera cable through the routing guides on the display-assembly base.
6. Place and slide the retractable-camera assembly on the display-panel base, aligning the screw holes on the retractable camera
assembly with the screw holes on the display-panel base.
7. Replace the two screws (M3x5) that secure the retractable-camera assembly to the display-assembly base.
8. Connect the camera cable to the system board.
Post-requisites
1. Replace the system-board shield.
2. Replace the back cover.
3. Replace the stand.
50
Replacing the camera
To Next Page
Loading...
