Removing the power-button board
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Topics:
• Prerequisites
• Procedure
Prerequisites
1. Remove the stand.
2. Remove the back cover.
3. Remove the system-board shield.
Procedure
1. Open the latch, and disconnect the power-button board cable from the system board.
2. Peel off the power-button board cable from the display-assembly base and slide it through the antenna cable.
3. Remove the screw (M3x5) that secures the power-button board to the display assembly base.
4. Lift the power-button board, along with its cable, off the display assembly base.
23
Removing the power-button board 43
To Next Page
Loading...
