Replacing the power-button board
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
1. Using the alignment post, align the screw hole on the power-button board with the screw hole on the display-assembly base.
2. Replace the screw (M3x5) that secures the power-button board to the display-assembly base.
3. Route and adhere the power-button board cable to the display-assembly base.
4. Slide the power-button board cable into the connector on the system board and close the latch to secure the cable.
Post-requisites
1. Replace the system-board shield.
2. Replace the back cover.
3. Replace the stand.
24
44 Replacing the power-button board
To Next Page
Loading...
