Replacing the display panel
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
1. Note the positions of the four jig screws on the display panel.
2. Place the display-assembly base in its upright position, and slide the display panel into the display-assembly base.
3. Push the display cable and the touch-screen cable (optional) through the slot on the display-assembly base.
4. Align the four jig screws on the display panel with the screw holes on the display-assembly base.
5. Push the display panel into the slot on the display-assembly base.
40
Replacing the display panel 65
To Next Page
Loading...
