Removing the media-card reader
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Topics:
• Prerequisites
• Procedure
Prerequisites
1. Remove the stand.
2. Remove the back cover.
3. Remove the system-board shield.
Procedure
1. Open the latch, and disconnect the media-card reader cable from the system board.
2. Peel off the media-card reader cable from the display-assembly base and slide it through the microphone cable and speaker cable.
3. Remove the screw (M3x5) that secures the media-card reader shield to the display-assembly base.
4. Lift the media-card reader shield from the display-assembly base.
5. Remove the screw (M3x5) that secures the media-card reader board to the display-assembly base.
6. Lift the media-card reader board from the display-assembly base.
21
Removing the media-card reader 41
To Next Page
Loading...
