Replacing the Computer Base
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer. After working inside your
computer, follow the instructions in After Working Inside Your
Computer. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Procedure
1 Slide the display cables and antenna cables through the cable slot on the
computer base.
2 Place the computer base on the stand assembly and align the screw
holes on the computer base with the screw holes on the stand assembly.
3 Replace the screws that secure the computer base to the stand assembly.
4 Connect the display cables to the system board.
5 Connect the antenna cables to the wireless mini-card.
Post-requisites
Replace the base cover.
28
To Next Page
Loading...
