Dell Inspiron 23 - Replacing the Power-Supply Unit; Procedure; Post-requisites

Replacing the Power-Button
Module
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer. After working inside your
computer, follow the instructions in After Working Inside Your
Computer. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Procedure
1 Place the power button in the display bezel and make sure that the
power button fits in the slot on the display bezel.
2 Adhere the Mylar over the power button.
3 Route the power-button module cable through its routing guide.
4 Connect the power-button cable to the control-buttons board cable.
5 Replace the screw that secures the power-button cable to the display
bracket.
Post-requisites
1 Replace the back cover.
2 Replace the computer base.
3 Replace the base cover.
76