Removing the USB Board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer. After working inside your
computer, follow the instructions in After Working Inside Your
Computer. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Prerequisites
1 Remove the base cover.
2 Remove the computer base.
3 Follow the procedure from step 1 to step 4 in “Removing the Hard Drive”.
Procedure
1 Peel off the tape from the USB-board cable.
2 Open the clip of the USB-board cable routing.
3 Using the pull tab, disconnect the USB-board cable from the USB board
and remove it from the cable-routing clip.
4 Remove the screw that secures the USB board to the computer base.
43
To Next Page
Loading...
