Replacing the USB Board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer. After working inside your
computer, follow the instructions in After Working Inside Your
Computer. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Procedure
1 Align the screw hole on the USB board with the screw hole on the
computer base.
2 Replace the screw that secures the USB board to the computer base.
3 Route the USB-board cable through the routing clip on the computer
base and close the routing clip.
4 Connect the USB-board cable to the connector on the USB board.
5 Adhere the USB-board cable to the USB board.
Post-requisites
1 Follow the procedure from step 5 to step 8 in “Replacing the Hard Drive”.
2 Replace the computer base.
3 Replace the base cover.
45
To Next Page
Loading...
