Table 10. System setup options—Power Management menu
Power Management
AC Recovery Enable or disable the automatic power-on when an AC adapter is connected.
• Power Off (default)
• Power On
• Last Power State
Enable Intel Speed Shift Technology Enable or disable the Intel Speed Shift Technology support.
By default, Enable Intel Speed Shift Technology is selected.
Auto On Time Enable to set the computer to turn on automatically every day or on a preselected
date and time. This option can be configured only if the Auto On Time is set to
Everyday, Weekdays, or Selected Days.
• Disabled (default)
• Every Day
• Weekdays
• Select Days
Deep Sleep Control Set the computer to conserve power while in Shutdown (S5) or Hibernate state.
• Disabled
• Enabled in S5 only
• Enabled in S4 and S5 (default)
USB Wake Support Enable the USB devices to wake the computer from Standby mode.
NOTE: This feature is only functional when the AC power adapter is
connected. If the AC power adapter is removed during Standby, the
system setup removes power from all the USB ports to conserve battery
power.
By default, Enable USB Wake Support is selected.
Wake on LAN/WLAN Enable or disable the feature that powers on the computer from the Off state when
triggered by a LAN signal.
• Disabled (default)
• LAN Only
• WLAN Only
• LAN or WLAN
• LAN with PXE Boot
Block Sleep When Block Sleep is enabled, the computer does not go to Sleep (S3) state.
By default, Block Sleep is not selected.
Table 11. System setup options—POST Behavior menu
POST Behavior
Numlock LED Enable or disable Numlock when the computer boots up.
By default, Enable Numlock LED is selected.
Keyboard Errors Set the computer to report keyboard-related errors when the computer boots up.
By default, Enable Keyboard Error Detection is selected.
Fastboot Enable to set the speed of the boot process by bypassing some of the compatibility
steps.
• Minimal
• Thorough (default)
• Auto
Extend BIOS POST Time Set the BIOS POST time for an additional pre-boot delay.
System setup 73