Removing and Installing Parts 119
NOTICE: To connect a network cable, first plug the cable into the network device
and then plug it into the computer.
14
Replace the computer cover, reconnect the computer and devices to
electrical outlets, and then turn them on.
15
If you installed a sound card:
a
Enter system setup (see "System Setup" on page 168), go to
Onboard
Devices
and select
Integrated
Audio
, and then change the setting to
Off
.
b
Connect external audio devices to the sound card’s connectors. Do
not connect external audio devices to the microphone,
speaker/headphone, or line-in connectors on the back panel. See "Back
Panel Connectors" on page 18.
16
If you installed an add-in network adapter and want to disable the
integrated network adapter:
a
Enter system setup (see "System Setup" on page 168), go to
Onboard
Devices
and select
Integrated NIC,
and then change the setting to
Off
.
b
Connect the network cable to the add-in network adapter’s
connectors. Do not connect the network cable to the integrated
connector on the back panel. See "Back Panel Connectors" on page 18.
17
Install any drivers required for the card as described in the card
documentation.
Removing a PCI/PCI Express Card
1
Follow the procedures in "Before You Begin" on page 99.
2
Remove the computer cover. See "Removing the Computer Cover" on
page 101.
3
Remove the screw holding the card retention bracket.
4
Lift the card retention bracket and set it aside in a secure place.
book.book Page 119 Monday, December 10, 2007 3:12 PM
To Next Page
Loading...
