126 Removing and Installing Parts
5
Remove the four screws securing the hard drive.
NOTICE: Ensure that you do not scratch the screw holes with the screw driver as
the hard disk circuit board assembly is exposed here.
6
Slide the drive out away from the front of the computer.
7
If removing this drive changes the drive configuration, then be sure to
reflect these changes in system setup. When you restart your computer,
enter system setup (see "System Setup" on page 168), then go to the
"Drives" section of the System Setup and under
Drive 0 through 3
, set the
Drive to the correct configuration.
8
Replace the computer cover (see "Replacing the Computer Cover" on page 160).
9
Connect computer and other devices to an electrical outlet.
1 hard drive 2 power cable 3 serial ATA data cable
4 system board connector 5 screws (4)
2
4
3
1
5
book.book Page 126 Monday, December 10, 2007 3:12 PM
To Next Page
Loading...
