Removing and Installing Parts 127
Installing a Hard Drive
1
Follow the procedures in "Before You Begin" on page 99.
2
Remove the computer cover (see "Removing the Computer Cover" on
page 101).
3
Check the documentation for the drive to verify that it is configured for
your computer.
4
Slide the hard drive into the hard drive bay.
5
Align the four screw holes in the hard drive with the screw holes in the
hard drive bay.
1 hard drive 2 power cable 3 serial ATA data cable
4 system board
connector
5 screw holes in the
hard drive bay (4)
6 screws(4)
2
4
3
1
6
5
book.book Page 127 Monday, December 10, 2007 3:12 PM
To Next Page
Loading...
