Installing base cover
1 Place the base cover to align with the screw holders on the system.
2 Press the edges of the cover until it clicks into place.
3 Replace the 7 M2.5x7 screws to secure the base cover to the computer.
4 Follow the procedure in After working inside your computer.
Battery
Removing battery
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a base cover
3 To remove the battery:
a Disconnect the battery cable from the connector on the system board [1].
b Remove the three M2x3 screws that secure the battery to the computer [2].
c Peel o the adhesive tape that secures the battery to the system [3].
d slightly hold the tape and lift the battery to release it from the adhesive beneath it [4].
12
Disassembly and reassembly
To Next Page
Loading...
