Dell Latitude 3190 2-in-1 - Installing System Board

Installing system board
1 Align the system board with the screw holders on the palm rest assembly.
2 Replace the ve M2x3 screws to secure the system board to the palm rest assembly.
3 Connect the display cable to the connector on the system board.
4 Place the metal bracket over the connector, and replace two M2x3 screws to secure the display cable to the system board.
5 Connect the WLAN cables.
6 Place the metal bracket on the WLAN card, and replace M2x3 screw to secure the WLAN cable on the WLAN card.
7 Place the metal bracket on the system board and replace two M2x3 screws to secure on the system board.
8 Connect the following cables:
a power connector cable
b touchpad cable
c keyboard cable
d speaker cable
e power board and audio cable
f coin cell battery cable
g world facing camera cable
h Replace the screw that secures the camera cable to the system board and ax the adhesive to secure the cable from the
system board
i sensor cable
9 Install the:
a SSD card
b battery
c base cover
10 Follow the procedure in After working inside your computer.
36
Disassembly and reassembly