Installing display assembly
1 Place the display assembly to align with the screw holders on the computer at 90 degree with keyboard facing the table.
2 Replace the six M2.5x5 screws that secure the display hinges to the palm-rest assembly.
3 Flip over the computer.
4 Connect the display cable to the connector on the system board.
5 Place the display cable bracket over the display cable connector, and replace the M2x3 screws to secure the display cable to the
computer.
6 Connect the WLAN cables.
7 Place the metal bracket on WLAN card, and replace the M2x3 screw to secure the metal bracket on the system board.
8 Install the:
a battery
b base cover
9 Follow the procedure in After working inside your computer.
Display back cover
30
Disassembly and reassembly
To Next Page
Loading...
