1 Align the notch on the solid-state drive with the tab on the solid-state drive slot and slide the solid-state drive into the solid-state drive
slot on the system board.
2 Replace the screw (M2x2.5) that secures the solid-state drive to the system board.
1 Install the battery.
2 Install the base cover.
3 Follow the procedure in After working inside your computer.
Removing the M.2 2230 solid-state drive
1 Follow the procedure in Before working inside your computer.
2 Remove the base cover.
3 Remove the battery.
The following image indicates the location of the solid-state drive and provides a visual representation of the removal procedure.
Removing and installing components
21
To Next Page
Loading...
