9. Align the screw holes on the right display hinge with the screw holes on the system board.
10. Replace the two screws (M2x3) to secure the right display hinge to the system board.
11. Align and place the display-cable bracket on the display-cable connector on the system board.
12. Replace the two screws (M2x3) to secure the display-cable bracket to the system board.
Next steps
1. Install the display assembly.
2. Install the thermal heat-sink.
3. Install the thermal fan.
4. Install the wireless card.
5. Install the M.2 2230 solid-state drive or the M.2 2280 solid-state drive, whichever applicable.
6. Install the 3-cell battery or the 4-cell battery, whichever applicable.
7. Install the base cover.
8. Follow the procedure in After working inside your computer.
Power-adapter port
Removing the power-adapter port
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the 3-cell battery or the 4-cell battery, whichever applicable.
4. Remove the M.2 2230 solid-state drive or the M.2 2280 solid-state drive, whichever applicable.
5. Remove the wireless card.
6. Remove the thermal fan.
7. Remove the thermal heat-sink.
8. Remove the system board.
NOTE:
The system board can be removed with the thermal heat-sink attached to it in order to simplify the procedure
and preserve the thermal bond between the system board and the thermal heat-sink.
About this task
The following images indicate the location of the power-adapter port and provide a visual representation of the removal
procedure.
Removing and installing components
61
To Next Page
Loading...
