Steps
After performing the preceding steps, you are left with the display back cover.
Installing the display back cover
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display back cover and provides a visual representation of the installation
procedure.
Steps
After performing the succeeding steps, you are left with the display back cover.
Next steps
1. Install the display cable.
2. Install the display hinges.
3. Install the camera.
4. Install the display bezel.
5. Install the display assembly.
6. Install the system board.
7. Install the heat-sink (UMA).
8. Install the fan.
9. Install the smart card reader I/O board.
10. Install the smart card reader.
11. Install the GPS board.
12. Install the inner frame.
13. Install the express card reader.
14. Install the rear I/O board.
15. Install the dock I/O board.
16. Install the WWAN card.
100
Removing and installing components
To Next Page
Loading...
