Steps
1. Slide the battery release latch to the unlock position.
2. Slide the latch down to unlock the battery.
3. Lift the battery out of the battery bay.
4. Remove the battery from the system.
Installing the batteries
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE:
Latitude 7330 Rugged Extreme can accommodate two hot-swap capable batteries (Primary and optional). The
installation procedure of the primary and optional battery are identical.
NOTE: BIOS displays a Battery error when non-Latitude 7330 Rugged Extreme batteries are used.
The following image indicates the location of the battery and provides a visual representation of the installation procedure.
Removing and installing components
25
To Next Page
Loading...
