Next steps
1. Install the system board.
2. Install the heat-sink (UMA).
3. Install the fan.
4. Install the smart card reader I/O board.
5. Install the smart card reader.
6. Install the GPS board.
7. Install the inner frame.
8. Install the express card reader.
9. Install the rear I/O board.
10. Install the dock I/O board.
11. Install the WWAN card.
12. Install the WLAN card.
13. Install the RF switch board.
14. Install the base cover.
15. Install the keyboard.
16. Install the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
17. Install the battery.
18. Follow the procedure in after working inside your computer.
Display bezel
Removing the display bezel
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the battery.
3. Remove the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
4. Remove the keyboard.
5. Remove the base cover.
6. Remove the RF switch board.
7. Remove the WLAN card.
8. Remove the WWAN card.
9. Remove the dock I/O board.
10. Remove the rear I/O board.
11. Remove the express card reader.
12. Remove the inner frame.
13. Remove the GPS board.
14. Remove the smart card reader.
15. Remove the smart card reader I/O board.
16. Remove the fan.
17. Remove the heat-sink (UMA)
18. Remove the system board.
19. Remove the display assembly.
About this task
The following images indicate the location of the display bezel and provide a visual representation of the removal procedure.
86
Removing and installing components
To Next Page
Loading...
