Steps
1. Place the dock I/O board and connect the dock I/O flexible printed cable to the system board.
NOTE: Adhere the dock I/O flexible printed cable with kapton tapes to the connector.
2. Flip the dock I/O board.
Next steps
1. Install the WLAN card.
2. Install the RF switch board.
3. Install the base cover.
4. Install the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
5. Install the battery.
6. Follow the procedure in after working inside your computer.
Global Positioning System (GPS)
Removing the GPS board
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
3. Remove the battery.
4. Remove the base cover.
About this task
The following images indicate the location of the Global Positioning System (GPS) board and provide a visual representation of
the removal procedure.
Steps
1. Unroute the GPS antenna from the routing guide and disconnect it from the Wi-Fi board and GPS board.
2. Remove the two (M2.5x5) screws that secure the GPS board to the system chassis.
3. Lift the GPS board from the system chassis.
Removing and installing components
49
To Next Page
Loading...
