Steps
1. Place the smart card reader into the slot on the system chassis.
2. Replace the four (M2x3) screws that secure the smart card reader to the system chassis.
3. Connect the smart card reader flat printed cable to the connector on the USH board.
Next steps
1. Install the express card.
2. Install the base cover.
3. Install the battery.
4. Install the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
5. Follow the procedure in after working inside your computer.
USH board
Removing the USH board
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
3. Remove the battery.
Removing and installing components
55
To Next Page
Loading...
