4. Remove the base cover.
About this task
The following images indicate the location of the USH board and provide a visual representation of the removal procedure.
Steps
1. Peel the adhesive tape and disconnect the smart card reader I/O board flat printed cable from the connector on the USH
board.
2. Remove the two (M2x3) screws that secure the USH board to the system chassis.
3. Lift and remove the USH board from the system chassis.
Installing the USH board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the USH board and provides a visual representation of the installation procedure.
56
Removing and installing components
To Next Page
Loading...
