Steps
1. Align the positioning holes of USH board with the system chassis.
2. Replace the two (M2x3) screws that secure the USH board to the system chassis.
3. Connect the smart card reader I/O board flat printed cable to the connector on the USH board.
Next steps
1. Install the base cover.
2. Install the battery.
3. Install the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
4. Follow the procedure in after working inside your computer.
Inner frame
Removing the inner frame
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
3. Remove the battery.
4. Remove the base cover.
Removing and installing components
57
To Next Page
Loading...
