About this task
The following images indicate the location of the rear I/O board and provide a visual representation of the removal procedure.
Steps
1. Peel the adhesive tape and disconnect the rear I/O flat printed cable.
2. Remove the two (M2x3) screws that secure the rear I/O board to the system board.
Installing the rear I/O board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the rear I/O board and provides a visual representation of the installation
procedure.
62
Removing and installing components
To Next Page
Loading...
