Steps
1. Align the rear I/O board with the screw holes on the system board.
2. Replace the two (M2x3) screws that secure the rear I/O board to the system board.
3. Connect the rear I/O flat printed cable.
Adhere the rear I/O flat printed cable with kapton tapes to the connector.
Next steps
1. Install the base cover.
2. Install the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
3. Install the battery.
4. Follow the procedure in after working inside your computer.
Right Type-C daughterboard
Removing the right Type-C daughterboard
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the battery.
3. Remove the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
Removing and installing components
63
To Next Page
Loading...
