About this task
The following images indicate the location of the smart card and provide a visual representation of the removal procedure.
Steps
1. Peel the adhesive tape and disconnect the smart card reader flat printed cable from the connector on the USH board.
2. Remove the four (M2x3) screws that secure the smart card reader to the system chassis.
3. Lift and remove the smart card reader from the system chassis.
Installing the smart card
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the smart card and provides a visual representation of the installation procedure.
54
Removing and installing components
To Next Page
Loading...
