About this task
NOTE: If either the system board or the thermal module is replaced, use the thermal grease provided in the kit to ensure
that thermal conductivity is achieved.
The following image indicates the location of the thermal module and provides a visual representation of the installation
procedure.
Steps
1. Place the thermal module on the system board.
2. Align the screw holes on the thermal module to the screw holes on the system board.
3. Replace the two screws (M2x2.5) to secure the thermal fan and four screws (M2x2.5) to secure the thermal heat-sink to
the system board.
NOTE: Replace the four screws (M2x2.5) in the sequential order mentioned on the thermal heat-sink [1 > 2 > 3 > 4].
4. Route the speaker cable into its routing guides, along the bottom side of the thermal fan.
Removing and installing components
47
To Next Page
Loading...
