5. Connect the speaker cable to the connector on the system board.
6. Connect the thermal-fan cable to the connector on the system board.
7. Align and place the system-board shield and solid-state drive thermal plate over their slots on the system board.
8. For Latitude 7430 2-in-1 computers, start from the top-right side of the system-board shield and press the system-board
shield onto the system board along with the solid-state drive thermal plate.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
WLAN-antenna module
Removing the WLAN-antenna module
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
NOTE:
This procedure applies only to computers shipped with a WLAN-antenna module installed on the palm-rest and
keyboard assembly.
The following images indicate the location of the WLAN-antenna module and provide a visual representation of the removal
procedure.
48
Removing and installing components
To Next Page
Loading...
