Steps
1. For computers shipped with a carbon fiber palm-rest, use a fine-tipped instrument to push the microSIM filler outwards to
remove it from its slot on the palm-rest assembly.
NOTE: The microSIM filler must be transferred to the new replacement palm-rest assembly.
2. After performing the pre-requisites, you are left with the palm-rest assembly.
Installing the palm-rest assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the palm-rest assembly and provides a visual representation of the installation
procedure.
96
Removing and installing components
To Next Page
Loading...
