Steps
1. Place the palm-rest and keyboard assembly on a flat surface.
2. Slide the display assembly at an angle and place the display assembly on the palm-rest and keyboard assembly.
3. Gently press down on the display hinges to align the screw holes on the display hinges with the screw holes on the palm-rest
and keyboard assembly.
4. Replace the four screws (M2.5x4) to secure the display hinges to the palm-rest and keyboard assembly.
5. Connect the touch-screen cable (for computers shipped with a touch screen), display cable, IR-camera cable (for computers
shipped with an IR camera), and sensor daughter-board cable (for computers shipped with a sensor board) to the system
board.
6. Adhere the tape to secure the display cable to the thermal module. Also, adhere the tape to secure the display cable to the
system board.
58
Removing and installing components
To Next Page
Loading...
