NOTE: When installing the SSD bracket, ensure that the tab on the bracket is held securely with the tab on the palm
rest.
NOTE: Ensure to install the bracket is the system is shipped with bracket.
3. Tighten the M2 x 3 screws to secure it the SSD bracket.
4. Connect the battery cable to the connector on the system board.
5. Install the base cover.
6. Follow the procedure in After working iinside your computer.
Speaker
Removing speaker module
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
3. To release the speaker module:
a. Push to disconnect the speaker cable from the connector on the system board [1].
NOTE: Ensure to unroute the speaker cable from the routing clip.
NOTE: Use a plastic scribe to release the cable from the connector. Do not pull the cable as it may result in
breakage.
b. Un-route the speaker cable from the routing clips [2].
c. Remove the tape that secures the speaker cables to the touchpad board [3].
Disassembly and reassembly
17
To Next Page
Loading...
