Installing touchpad buttons board
1. Insert the touchpad buttons board into the slot to align the tabs with the grooves on the computer.
2. Tighten the M2.0 x 3.0screws to secure the touchpad buttons board to the computer.
3. Connect the touchpad buttons board cable to the connector on the touchpad board.
4. Affix the smart card cable and connect it to the connector on the computer
5. Install the:
a. speaker
b. battery
c. base cover
6. Follow the procedure in After working inside your computer.
Power connector port
Removing power connector port
1. Follow the procedure in Before working inside your computer.
2. Remove the :
a. base cover
b. battery
3. To remove the power connector port:
a. Disconnect the power connector port cable from the system board [1].
NOTE: Ensure to remove the adhesive tape that covers the connector.
28 Disassembly and reassembly
To Next Page
Loading...
