Steps
1. Align the screw holes on the heat sink with the screw holes on the system board.
2. Tighten the three captive screws that secure the heat sink to the system board.
3. Adhere the heat absorber for the DDR5 onboard memory on the heat-sink.
4. Replace the heat shield cover.
Next steps
1. Install the base cover.
2. Install the SIM card tray.
3. Install the SD card.
4. Follow the procedure in After working inside your computer.
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
NOTE:
Ensure that your computer is in Service Mode. For more information see, step 6 in Before working inside your
computer.
2. Remove the SD card.
3. Remove the SIM card tray.
4. Remove the base cover.
About this task
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
NOTE: The display assembly removal procedure is the same for both laptop and 2-in-1 chassis.
Removing and installing components 33
To Next Page
Loading...
